RBJ-30TL
30-Ton Air Bottle Jack
8
P/N 5900031 — Rev. B — Jan. 2020
To set up your Jack
:
1.
Remove the components from the box.
2.
The Handle comes folded: remove the pin, straighten out the Handle, put the pin back in.
3.
Switching to the Wheels, remove
both
Wheels; a 10 mm hex wrench is included for this.
Keep the Bolts, Washers, Wheels, and Wheel Spacers together as a unit when you remove
them. You are going to be putting them back into place soon.
4.
Put the Handle bottom into place, outside of where the Wheels connect to the Chassis.
The Angle Pin needs to be next to the Angle Holes.
5.
Take one of the Wheels you just removed: put the Bolt and Washer into place on the outside,
put the Wheel Spacer into place on the inside, then push the Wheel into place; the Threads on
the Bolt must go through the hole in the Bottom of the Handle and into the Base of the Jack.
Top view. Left side shows components without the Wheel, for clarity. Right side shows
components when all are in place. Not necessarily to scale. Not all components shown.
6.
Tighten the Bolt into place using the 10 mm hex wrench.
7.
Repeat Steps 5 and 6 for the other Wheel.
