LS43B Laser-Spot™ Wheel Balancer
19
P/N 5900086 — Rev. A1 — 12/212018
Installing the Shaft
The Shaft holds the Wheels you are balancing.
Tip
Consider having two people on hand to install the Shaft: one person to hold the Shaft
Assembly in place while the second person screws in the Mounting Bolt. Also, consider
having some rags nearby; the Shaft comes greased to protect it.
To install the Shaft
:
1.
Locate the Shaft Assembly and the Mounting Bolt from the parts supplied with the Balancer.
2.
Clean the Shaft Assembly by removing the shipping grease and any dirt that has accumulated.
3.
Put the Shaft Assembly into place next to the Shaft Housing and hold it there.
Note
: It is easier to install the Shaft with two people.
4.
Put the Mounting Bolt into the end of the Threaded Shaft and
begin
tightening it.
5.
Before fully tightening
the Mounting Bolt, make sure the Alignment Marks are aligned (see drawing
below).
Not necessarily to scale. Not all components shown.
6.
Tighten the Mounting Bolt into place.
Summary of Contents for Laser-Spot LS43B
