Unpacking your new 501 Atlas
Alignment Machine
Congratulations on the purchase of your new Atlas
Alignment Machine. This memo is provided to get you
up and going in the fastest possible manner.
1.
Your machine is ready to go out of the box. There is no need to install
software, calibrate, or do anything other than proceed with cable
installation.
2.
Unscrew the four screws on the front panel of the machine and four screws
on the back cover of the machine. Note: the back cover will have a ground
wire attached so be careful not to pull it lose when you sit this to the side.
3.
If you have a 501 model the only connections that will need to be made will
be at the back of the computer. You will plug in the usb cables, monitor
cable (VGA), printer usb cable, and power cable.
