32
Mount/Demount Head Cleaning
1. Inspect inserts and clean dirt and debris from the
mount/demount tool roller with small screw driver or pick.
(See Fig.17.4)
Water Separator/Lubricator Maintenance
Check oil and water levels regularly, and perform these
maintenance items weekly:
1. Disconnect air supply to machine. (See Fig. 17.5)
2. Observe the sight glass on the water separator/filter
unit. If water is observed, drain by pressing upwards on the
drain plug at the bottom of the reservoir. (See Fig. 17.6)
3. Add oil to the lubricator if the fluid level is below the
middle of the sight glass. Remove the reservoir by turning
counter-clockwise and pulling down. Add SAE 10W non-
detergent oil or an air tool oil if necessary.
4. Reconnect the air when service/adjustments are
complete.
Oiler Adjustment
NOTE:
This adjustment will require two persons to perform.
1. With the Air source connected, depress the Bead
Breaker Pedal to operate the Bead Breaker.
2. Observe the site glass and adjust the oil flow of the oiler
by turning the Oiler Adjustment Knob so that 2-3 drops of oil
drip through the site glass for each operation of the Bead
Breaker Pedal. (See Fig 17.7)
(Either reservoir may be removed for cleaning by turning the
reservoir counter-clockwise and pulling down.)
3. Reconnect the air supply when service/adjustments are
complete.
Fig. 17.5
Fig. 17.6
Fig. 17.7
Fig. 17.4
