Installation Preparation
Installation Preparation
Installation Preparation
Installation Preparation
⚠
You must install the mixertap and filter before the boiler.
⚠
Before installing the new mixer it is essential that you thoroughly flush through the supply pipes
flush through the supply pipes
flush through the supply pipes
flush through the supply pipes in order
to remove any remaining solder, swarf or impurities from your system. Failure to carry out this simple
procedure could cause problems or damage to the workings of the mixertap or boiler.
We recommend installing particle filters (not shown) and isolation valves (G1) to both the hot and cold
feed pipes in an accessible position. This will help to prevent premature failure of the valves and ease any
future maintenance.
⚠
Ensure you have suitable domestic hot and cold water pressure before installing this product (see
technical data).
All parts should be removed from their packaging and inspected for any transport damage and
completeness prior to installation.
Loosely position the tap, pipes and other principal supply components to check if any alterations to the
existing supply pipework is required, if this is the case do this now.
⚠
Shut off your water heating system and ensure that your mains stopcock is closed. Open the lowest hot
and cold taps in the house and allow the water to run until fully stopped.
If replacing an existing tap, remove the tap & clean the end of the feed pipes using wire wool, the tap hole area
should be free from dirt and sealant.
This mixertap requires a Ø35mm tap hole, as both
handles rotate backwards and forwards you should
allow for this distance “A
A
A
A” behind the tap when
planning the sink and tap hole location as shown.
This tap is designed to be installed in a
This tap is designed to be installed in a
This tap is designed to be installed in a
This tap is designed to be installed in a worktop
worktop
worktop
worktop
with a maximum thickness of 45
with a maximum thickness of 45
with a maximum thickness of 45
with a maximum thickness of 45mm.
mm.
mm.
mm.
For this product “A” should be no less that 70mm
For this product “A” should be no less that 70mm
For this product “A” should be no less that 70mm
For this product “A” should be no less that 70mm
(Tap hole centre to tiled wall or backsplash face)
(Tap hole centre to tiled wall or backsplash face)
(Tap hole centre to tiled wall or backsplash face)
(Tap hole centre to tiled wall or backsplash face)