After Installation
After Installation
After Installation
After Installation
1.
Ensure that the isolating Tee valve (G7) is in the closed position as
shown.
2.
Close (turn off) both handles on the tap.
3.
Reconnect the domestic hot and cold water supplies and open hot
and cold isolation valves (G1). As the system starts to refill, check
carefully all new water connections for leaks. After the product
installation is complete we recommend you recheck for any slower
leaks.
⚠
It is normal for new filter cartridges to lose a small amount of loose carbon when first used and will
dissipate with flushing, whilst harmless to consume if the carbon particles are not flushed prior to connection
to the boiler they may partly block the boiler and reduce the flow rate. You mu
You mu
You mu
You must flush the filter for at least 2
st flush the filter for at least 2
st flush the filter for at least 2
st flush the filter for at least 2
litres with cold water or until the water become clear
litres with cold water or until the water become clear
litres with cold water or until the water become clear
litres with cold water or until the water become clear (without black carbon particles).
4.
Ensure that the isolating Tee valve (G7) is in the open position as
shown.
5.
Place the ¼” pipe (B4) from the tap into a bowl or bucket.
6.
Turn on the 98°C forwards handle fully, keep the lever open until all
air is expelled and cold (filtered) water exits the ¼” pipe (B4) into
the bowl, flush a minimum of a further 2 litres of cold (filtered)
water through the ¼” pipe (B4). You may notice a discolouration to
the water at first, this is loose carbon particles from the filter it is
normal, harmless and will pass with flushing. Continue to flush the
filter until the water runs clear. Once complete turn off the 98°C
handle.
19.
You can adjust the flow rate of the filtered water going to both the tap and boiler by adjusting the position
of the blue lever on the isolating Tee valve (G7), you should aim for approximately 1-2 litres for both cold
filtered and boiled filtered water.
20.
Please refer to ‘PROBOIL.2X User & Installation Guide’ for the next steps on how to install the boiler and
Please refer to ‘PROBOIL.2X User & Installation Guide’ for the next steps on how to install the boiler and
Please refer to ‘PROBOIL.2X User & Installation Guide’ for the next steps on how to install the boiler and
Please refer to ‘PROBOIL.2X User & Installation Guide’ for the next steps on how to install the boiler and
connect the tap and filter.
connect the tap and filter.
connect the tap and filter.
connect the tap and filter.
Meadow Lane, Long Eaton, Nottingham, NG10 2GD, England
Trade Enquiries: +44 (0)115 946 4000
Consumer Enquiries: +44 (0)1926 457628
E-mail: [email protected] www.rangemaster.co.uk
Please leave these instructions for your customer
06/2022