Manual-8
REAR PANEL: MONO 4-WAY AND MONO 5-WAY INSTALLATION
Observe the labels
below
the Inputs and Outputs for mono operation.
햲
MONO INPUT:
These ¼" Inputs accept either balanced TRS (tip-ring-sleeve) or unbalanced TS (tip-sleeve) plugs.
Connect the output from your mixer or other signal source only to the CHANNEL 1 INPUT for Mono operation—
do not
use the Channel 2 Input
. As long as no plug is inserted into the Channel 2 Input the AC 23 will internally switch itself to
Mono operation.
햳
SUBWOOFER OUTPUT:
These are ¼" TS (tip-sleeve) unbalanced Output jacks. Connect the SUB OUT to the input of
the subwoofer (or bass bin) amplifier .
햴
LOW FREQUENCY OUTPUT:
Connect the LOW OUT to the input of the low frequency (mid-bass) amp.
햵
MID FREQUENCY OUTPUT:
Connect the MID OUT to the input of the mid frequency amplifier.
햶
Hl MID FREQUENCY OUTPUT (FOR MONO 5-WAY ONLY):
Use this output only for Mono 5-Way applications.
Omit this output when using the AC 23 as a Mono 4-Way Crossover. As long as no plug is inserted into this jack the AC 23
internally bypasses the Hi Mid section and defeats all front panel Hi Mid Controls. For Mono 5-Way connect the HI MID
OUT to the input of the hi mid frequency amplifier.
햷
HIGH FREQUENCY OUTPUT:
Connect the HIGH OUT to the input of the high frequency (tweeter) amp.
햸
2-WAY/3-WAY SWITCHES:
Converts the outputs in each channel from 3-Way to 2-Way. Be sure to slide the switches to
the 3-WAY position for mono 4- or 5-Way operation.
햹
Power input connector:
Use only a model RS 1 or other power supply approved by Rane. This unit is supplied with an 18
VAC center tapped remote power supply suitable for connection to this input jack. Contact Rane for a replacement or
substitution.
햺
Chassis ground point:
A #6-32 threaded hole used for chassis grounding purposes. Always connect the crossover chassis
to the amplifier chassis. See the CHASSIS GROUNDING note on page Manual-7 for details.