Manual-3
Observe the labels
above
the Inputs and Outputs for Stereo operation.
햲
CHANNEL 1 INPUT:
These ¼" Inputs accept either balanced TRS (tip-ring-sleeve) or unbalanced TS (tip-sleeve) plugs.
Connect the output of the mixer, equalizer or other signal source to this input. Note: Use this input only if you are running
two separate channels from the mixer or other source. Connect this input to the left channel output of the mixer, equalizer or
other signal source. If you are running two speaker systems from a single mono signal, omit this input and use only the
CHANNEL 2 INPUT. See #2 below.
햳
CHANNEL 2 INPUT:
For true stereo operation, connect this Input to the right channel output of the mixer, equalizer or
other signal source. NOTE: Two separate speaker systems may be independently operated from a single mono source by
using only the CHANNEL 2 INPUT and omitting the Channel 1 Input. As long as nothing is plugged into the Channel 1
Input, CHANNEL 2 will drive BOTH Channels of the AC 23 internally.
햴
HIGH FREQUENCY OUTPUTS:
These are ¼" TS (tip-sleeve) unbalanced Output jacks. Connect the CHANNEL 1
HIGH OUT to the left channel input of the high frequency amplifier, and the CHANNEL 2 HIGH OUT to the right channel
input of the high frequency amp.
햵
MID FREQUENCY OUTPUT:
Connect the CHANNEL 1 MID OUT to the left channel of the mid frequency amplifier,
and the CHANNEL 2 MID OUT to the right channel of the mid amplifier.
햶
2-WAY/3-WAY SWITCH:
Converts the outputs from Stereo 3-Way to Stereo 2-Way. Be sure to slide the switches to the
2-WAY position.
햷
POWER input connector:
Use only a model RS 1, or other remote AC power supply approved by Rane. This unit is
supplied with a remote power supply suitable for connection to this input jack. This is an 18 VAC center tapped power
supply. Contact Rane for a replacement or substitution.
햸
Chassis ground point:
A #6-32 screw is used for chassis grounding purposes. Always connect crossover chassis ground to
amplifier chassis ground. See the CHASSIS GROUNDING note on page Manual-7 for details.
REAR PANEL: STEREO 2-WAY INSTALLATION
