R&S SMJ100A, Operating Manual

Page: 504 / 874

Remote Control Commands
R&S
®
SMJ100A
488 Operating Manual 1403.7458.32 ─ 14
Return values:
<ErrorCode> integer > 0 (in decimal format)
An error occurred.
(For details see the Service Manual supplied with the instru-
ment).
0
No errors occurred.
Usage: Query only
*WAI
Wait to continue
Prevents servicing of the subsequent commands until all preceding commands have
been executed and all signals have settled (see also command synchronization and
*OPC
).
Usage: Event
7.3 Preset Commands
The preset commands are not bundled in one subsystem. Therefore, they are listed
separately in this section. In addition, a specific preset command is provided for each
digital standard and for the fader. These specific commands are described in the asso-
ciated subsystems.
Four presetting actions are available:
●
Activating the default state of all internal instrument functions (
*RST
on page 486).
Functions that concern the integration of the instrument into a measurement setup
are not changed, e.g. GPIB address or reference oscillator source settings.
●
Activating the preset state of the parameters related to the selected signal path (
:
SOURce<hw>:PRESet
on page 489)
●
Activating the preset state of all parameters that are not related to the signal path
(
:DEVice:PRESet
on page 488)
●
Activating the original state of delivery (factory reset,
:SYSTem:FPReset
on page 489). Only functions that are protected by a password remain unchanged
as well as the passwords themselves.
:DEVice:PRESet
Presets all parameters which are not related to the signal path, including the LF gener-
ator.
It also includes presetting the bit/block error measurement.
Example: presets all instruments settings that are not related to the signal
path
Usage: Event
Preset Commands