R&S M3SR 4100 Series, Operating Manual

Page: 240 / 706

M3SR Series 4100 User Level
3.124 Operating Manual 6175.4760.02 – 01
After confirming this entry with 'ENT', the system-wide user level will be set to level 1.
The password can have a length of up to 32 alphanumeric characters (uppercase letters, nu-
merals). The editor always shows the 15 rightmost characters of a password. Within the dis-
played portion of a password, it can be edited. Selection of the character to be edited is done
by pressing “.” (dot) until the desired position gets highlighted.
Deletion of characters always starts at end of the password and is done by pressing 'ESC
CLR'.
Characters can be entered by turning the wheel until the desired character appears, then
confirming this character by pressing “.” (dot). Numeric entry is also possible by means of the
keypad.
Alternatively, it is possible to have a low system-wide user level set and enter the PIN if it is
necessary to use a sofkey which requires a higher user level.
Softkeys which require higher user levels than the currently set system-wide level, are
marked with a lock symbol (
) at the left or right top corner.
The password editor now displays which user level is required for the selected action. For
example: Level 1/2. This means, that the level 1 password as well as the level 2 password
will start the action. Now enter the correct password and press 'ENT'. The action behind the
softkey is started.
Please keep in mind that this proceeding only unlocks the softkey for ONE action. After per-
forming this action, the softkey will be locked again. It also does NOT change the radio wide
system user level setting.