R&S M3SR 4100 Series, Operating Manual

Page: 110 / 706

M3SR Series 4100 Basic Configuration of the Control Unit
2.40 Operating Manual 6175.4760.02 – 01
2.9 Basic Configuration of the Control Unit
The control unit IP configuration consists of two parts.
• The control unit IP Settings: IP address, netmask and gateway. The IP address uniquely
identifies the control unit within the LAN (see Figure 2.20).
• A list of radios the control unit can connect to. The 'Radio IP Address List' (see
Figure 2.21).
The following description guides through the individual steps required to change the control
unit default IP settings and the default entry in the Radio IP Address List of the control unit
(see Table 2.2).
Table 2.2 Default IP Settings of Control Unit
Be careful if you change the IP settings. For the configuration of a greater network,
detailed knowledge concerning IP networks is required. Such knowledge is not im-
parted by this documentation. Please ask your network administrator or refer to ap-
propriate technical literature if necessary.
To change the default IP settings and the radio IP address list of the control unit, proceed as
follows:
Default Control Unit IP Address 192.168.52.4
Default Control Unit IP Netmask 255.255.255.000
Default Control Unit IP Gateway 0.0.0.0 (no gateway)
Radio IP Address List first logical address (default) Logical address Radio IP address
34 (not selected as local,
see Figure 2.21) 192.168.52.34
1. Switch the control unit on (see sect. 2.6 Switching the Radio On)
2. Press softkey to make sure that the control unit is disconnected from the radio.
3. Press softkeys and the display appears as shown in Figure 2.20.