Installation and Configuration
R&S FS300
E-1007.9900.15
7-180
Operating manual, 02/2006
7.2
Installation and Configuration
System requirements
The PC software runs on Windows
™
2000 and XP operating systems with
USB interface.
7.2.1
Installing the PC Software
NOTE
To install the PC software, you must have administrator rights on your PC. (
Windows
™
help).
Introduction
The PC software is installed in two steps. Firstly the remote control program
for the R&S FS300 is installed. The R&S FS300 must not be connected at
this time. Secondly the drivers are installed; at this time the instrument has to
be connected.
7.2.1.1
Installing the Program
NOTE
The <Back> button enables the user to go back one step during installation.
Installation can be interrupted by pressing <Cancel>.
Installation steps
1.
Place the CD ROM, which came with the product, in your installation
drive. The autorun function automatically initiates installation. Alterna-
tively you may also initiate the installation in the start menu of Windows
™
Start\Run
using the
Setup.exe
from the CD.
The installation is prepared and the installation wizard appears.
Summary of Contents for FS300
Page 1: ...2 2006...
Page 16: ......
