WCDMA Signaling
R&S
®
CMW-KG4xx/-KM4xx/-KS4xx
184
User Manual 1173.9657.02 ─ 11
Keep Test Loop during Reconfiguration
......................................................................184
.........................................................................................185
Loop Mode 2 Sym. UL CRC / UL CRC
......................................................... 185
......................................................................................185
................................................................................... 186
............................................................................................... 187
........................................................................... 187
Type
Selects the test mode connection type.
Option R&S CMW-KS401 is required for HSPA / RMC + HSPA.
●
RMC
: RMC in CS domain, no PS connection
●
HSPA
: HSDPA or HSDPA+HSUPA in PS domain, no CS connection
●
RMC + HSPA
: RMC in CS domain, HSDPA or HSDPA+HSUPA in PS domain
●
Cell FACH 34.108
: Test defined in 3GPP TS 34.108 and 34.121 using
CELL_FACH state (replaces SRB type CELL_FACH, see
). The feature "Cell
FACH 34.108 " is not available in the reduced signaling.
Remote command:
Keep Test Loop during Reconfiguration
Specifies whether the test loop is kept closed when the operating band or the carrier
frequency is reconfigured for an established test mode connection with test loop.
By default, the loop is opened before reconfiguration and closed again after reconfigu-
ration. If the UE supports keeping the loop closed during reconfiguration, you can
speed up the procedure by enabling this parameter.
Remote command:
RMC
The following parameters configure an RMC test mode connection. (For background
information see
chapter 2.2.11.1, "Reference Measurement Channel (RMC)"
Data Rate ← RMC
Information bit rate of the downlink and uplink reference channel in kbps.
Option R&S CMW-KS410 required.
Remote command:
GUI Reference
深圳德标仪器
135-1095-0799