Page
7
of
26
LP0343
R&G
Unit
1
, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)
1
420 89007 Fax: +44 (0)
1
420 87301 www.rg-racing.com Email: [email protected]
FITTING INSTRUCTIONS
Before fitting the R&G tail tidy you will need to remove some OEM parts. Below is a suggested
list of parts to be removed.
•
Rear seat
•
Rear side panels
•
Under rear seat cover plate
•
OEM number plate bracket
•
Seat lock mechanism
•
OEM indicators
•
Unplug indicator and number plate light wires
Tail Tidy Assembly
Before assembling this product, ensure all the components within the box are correct by
comparing the
legend
and
diagrams
.
1.
To start assembling the tail tidy, connect
(ITEM 1)
and
(ITEM 2)
together using x4
(ITEM 8)
(ITEM 11) (ITEM 13)
as shown in
DIAGRAM 1-2
.
DO NOT FULLY TIGHTEN AT THIS STAGE.
2.
Connect
(ITEM 3)
to the now constructed assembly
(ITEM 1/2)
using x4
(ITEM 8) (ITEM
11) (ITEM 13)
as shown in
DIAGRAM 1-2
.
3.
Once
(ITEM 3)
is connect, you can attach
(ITEM 15)
into the mounting holes on
(ITEM 3)
as
shown in
DIAGRAM 2
.
MAKE SURE WIRES ARE PLACED THROUGH
(ITEM 3)
. Once tightened,
slide the
HEAT SHRINK (ITEM 16)
over the wires of
(ITEM 15).
4.
As shown in
DIAGRAM 1
push
(ITEM 14)
into the hole of
(ITEM 1)
.
5.
To help cable tidy the wires, you will need to use the SELF-ADHESIVE CABLE CLIP
(ITEM 18)
to pin the wires to the inside of
(ITEM 1)
on either side.
6.
Push the cables through the hole in
(ITEM 14)
.
7.
To install the
TAIL BRACKET MOUNTING SPACERS (ITEM 4)
, you will need to directly
replace the OEM SPACERS as shown in
PICTURE 1.
8.
Now the Tail Tidy is assembled, it is time to attach it to the motorbike. To do so place the
assembly in the same mounting location as the OEM number plate bracket using x2
(ITEM 6) (ITEM 9) (ITEM 12)
.
