R&G Racing
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
Picture 37
Picture 38
Picture 39
Picture 40
FITTING INSTRUCTIONS
To fit the R&G tail tidy, remove the pillion seat using the key and the rider’s seat by removing the
two bolts under each corner of the seat, as shown in picture 1.
On the underside of the tail unit, remove the five push rivets, as shown in picture 2. This will allow
the plastic splash guard to come away from the bike, as shown in picture 3.
On top of the tail section, remove the two Phillips screws which secure the small joining panel
above the rear light in place and gentle pull the panel off towards the rear of the bike, as shown in
pictures 4 & 6.
Remove the two Philips screws securing the front joining panel before gently unclipping and
removing from the bike, as shown in picture 5.
Remove the two 6mm allen key bolts that secure the two side panels and have a spacer behind
them, as shown in picture 6.
On the tail section side panels, remove the 8mm bolt and 4mm allen key bolt that are located on
each side, as shown in picture 7.
Do this on both sides of the bike.
