Page
27
of
27
AB0036
R&G
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
•
Sicherstellend, dass der Expander komplett in das Rahmenrohr eigesetzt ist, vorsichtig die
Schraube anziehen, bis der Einsatz sich nicht bewegen kann – siehe Abbildung 11. Der
Rahmeneinsatz wird innerlich expandieren
.
NICHT ÜBERZIEHEN - DIES KANN ZUR
BESCHÄDIGUNG DES LACKS AN DER INNENSEITE DES RAHMENROHRS FÜHREN.
•
Mit einem 4mm Inbusschlüssel die unteren Schrauben für die Verbindungsstange mit dem
empfohlenen Anzugsdrehmoment festziehen.
•
Die M10 Sechskant-Gummikappe (Artikel 13) am Schraubenkopf anbringen – siehe
Abbildung 12
•
Kontrollieren Sie nun, dass die Verbindungsstange sicher befestigt ist und dabei weder den
Auspuff noch den Motor berühren kann, und dass alle Schrauben mit dem richtigen
Anzugsdrehmoment festgezogen wurden. Machen Sie eine Probefahrt mit dem Motorrad und
überprüfen Sie die Position der Sturzbügel und die Festigkeit der Schrauben – wenn
notwendig, entsprechend einstellen.
•
Überprüfen Sie alle Schrauben regelmäßig z.B. wenn Sie das Motorrad reinigen, um
sicherzustellen, dass diese fest angezogen Sie und die Sturzbügel somit in Position bleiben.
AUSGABE 1 18/02/2019 (DM)
CONSUMER NOTICE
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do not diminish their
performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no representation or warranty (other than as to
title) has been given or will apply to the Products other than those in R&G’s order or confirmation and the Buyer confirms it has chosen the Products as being of
merchantable quality and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and
rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the motorcycle is not affected
by the fitting of the Products. On return of any defective Products R&G shall at its option either supply a replacement or refund the purchase money but shall not be
liable if the Products have been modified or used or maintained otherwise than in accordance with R&G’s or manufacturer’s instructions and good engineering practice
or if the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall
not be liable for indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or the fitting or service
concerned. These terms do not affect the Buyer’s statutory rights.
R&G RETURNS POLICY (NON-FAULTY GOODS)
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were purchased direct from us
(customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable condition, in the opinion of R&G. All returns are
subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all
carriage charges. No returns of discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty
goods.
