RAND KAR s.a. ASSEMBLY MANUAL XAIR HANUMAN 2007 October, 15
Page 12 / 88
A13)
Install the U pulleys support on the floor.
Install rudder pedals.
Lubricate nylon housings with silicone grease.
A13)
Reposer le support de poulies.
Poser les paliers de palonniers et les palonniers 351.
Lubrifier les paliers a l’aide de graisse silicone.
A12)
Remove pulley supports from tubes 364.
Install floorboard 378. Caution, the floor is not symmetrical, the holes in the floor for
throttle handles must be located on the left side.
Drill the missing holes in the floor through the holes in the tubes.
Install pulley supports on tubes 364.
A12)
Déposer les supports de poulies des tubes 364.
Poser le plancher 378. Attention, il y a un sens de pose, les lumières de passage des manet-
tes de gaz dans le plancher doivent se trouver coté gauche.
Contrepercer les trous manquant dans le plancher à travers les tubes sous plancher.
Reposer les supports de poulies sur les tubes 364.
A12
A
A13
A13A
All manuals and user guides at all-guides.com
