Important Safety Instructions
WARNING
To reduce the risk of fire, electrical shock or injury when using your
appliance, please follow these basic instructions.
Read all instructions before using the water dispenser.
Never clean parts with flammable fluids. The fumes can create a fire hazard or
explosion.
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of
this or any other water dispenser. The fumes can create a fire hazard of explosion.
INSTALLATION GUIDELINES
Remove the exterior and interior packing.
Place your appliance on a floor that is strong enough to support the dispenser when it is fully
loaded. The unit is provided with four plastic feet. If it does not sit level on the floor, adjust the front
feet to level the unit well to the floor.
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the appliance not to perform
properly.
Allow 2 inches of space between the water dispenser and the wall, which allows for proper air
circulation to cool the compressor.
Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not cut or remove
the third (ground) prong from the power cord under any circumstances. Any questions concerning
power and/or grounding should be directed toward a certified electrician or an authorized products
service center.
This water dispenser is not recommended for outdoor usage.
Do not locate the dispenser in the area where the temperature may fall below freezing point (0
℃
or 32
℉
).
Keep area around dispenser free of dust and dirt.
Keep the reserve supply of water bottles away from excessive heat and light.
PRE-OPERATION INSTRUCTIONS
Before connecting the appliance to the power source. Let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Check and make sure the backside hot water drainage hole cap is not leaked or broken.
The water dispenser is pre-cleaned at the factory but the reservoir and water lines must be flushed
with fresh water before use as follows:
Keep the unit unplugged.
Fill water tank with tap water full to capacity. Wait for 5 minutes until water settles.
Push the hot water faucet until water comes out, then stop the faucet.
Plug the dispenser into the electrical outlet. We are ready to complete the first cycle. In order to do
that, wait for the hot water to reach temperature in approximately 10 minutes, and then wait for the
cold water to reach temperature in other 40 minutes approximately.
