Unplug the dispenser from the electrical outlet. Proceed to drain the water from the faucets one at
a time until no more water remains. (Note: To facilitate this operation, use a large container).
Then, drain any water left in the tanks by opening the backside hot water drainage hole cap, until
all water drains completely. After that, screw up the cap tightly.
Put the bottled purified or other dean water on the top cover one minute.
Push water faucet buttons to insure water flows from both faucets.
Plug dispenser again into the electrical outlet.
Now you are ready to use your water dispenser.
NOTE:
Your water dispenser has been cleaned and sanitized before leaving the factory, but in case a
taste problem develops, place two tablespoons of baking soda and add tap water. Fill water tank again
and repeat basic operations, except turn hot water function “OFF” to avoid leaving residues in hot
water tank.
OPERATION
Ambient temperature: 10 ~ 38
℃
Atmosphere 86 ~ 106kpa
When using the bottles holding ultra-pure water, distilled water or space water with the so-called
clever lid, tear off the hygienic label on the lid, place the bottles at the intake, then the core of
water guard will automatically open the valve and seal it in the meantime, when moving the bottles,
the valve will also seal automatically to avoid any possible oozing.
Push the hot water faucet, bubbles are generated inside the bottle, indicating that water is flowing
into hot water and cold water tanks, keep pressing the hot water valve until water flows out,
dispensing cold water required need no particular adjustment.
Do not connect the electrical power plug, until water comes out of the hot water faucet.
After plug, the yellow LED indicator will be on indicating the power is “ON”.
Turn on the heating switch, the red LED indicator will be on and the heating system starts working.
When the hot water comes up to 85-95
℃
or so, the red light goes off, the heating system stops
working. The machine turns to the warm-keeping status. When the hot water temperature is lower
than 85
℃
,the heating system will resume working automatically.
Turn on the cooling switch, the green LED indicator will be on and the cooling system starts
working. When the cold water falls down to 6-10
℃
, the green light goes off, the cooling system
stops working. The machine turns to the cold-keeping status. When the cold water temperature
goes up to a set degree, the cooling system will resume working automatically.
Since the temperature has already been adjusted before leaving the factory, it is unnecessary for
customers to set the temperature.
Turn the heating and cooling switches on. Then the heating and cooling processes start working
together.
If the device is not applied for a long time, after the hot water cools down, please remove the
power plug and revolve the drain cap to drain the rest water in the hot tank then tighten the cap.
Open the cold water faucet to drain the rest water in the cold tank.
If there is no water flowing from cooling faucet, please shut down the cooling switch until there is
water flowing out.
If you do not plan to use the water heating function for more than three days, we strongly
recommend that you turn off the hot water function.
