TAKING DISPENSER OUT OR SERVICE
If the water dispenser will not be used for a long period of time, unplug the power supply cord.
Turn off the hot water.
Drain the water through the faucets.
Drain the water from tanks by drainage hole from the back of the dispenser.
CAUTION
Do not use the bottle with any crack, leakage or holes.
The back of the product should be put in shady places and kept away from wall and
high-temperature elements. Please also put the product away from TV, video, or other valuables.
Do not turn on “heating” switch until water comes out of hot water faucet to prevent any damage
on the heating tube.
During operation keep it beyond the children to avoid scald.
Never turn on the heating switch when there is no water.
When carrying it, the angle of inclination should be less than 45
.
Adopt the ground wire to avoid any electric shock.
In the process of using, check the water receptacle frequently. If the water receptacle is full,
please pour the water out in time.
Do not turn on and off the “cooling” switch in three minutes to protect the compressor and extend
the compressor usage life.
This appliance is not intended for use by persons (including children) with reduced physical
，
sensory or mental capabilities
，
or lack of experience and knowledge
，
unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for their
safety.
Children should be supervised to ensure that they do not play with the appliance.
House hold used only.
If the supply cord is damaged
，
it must be replaced by the manufacturer
，
its service agent or
similarly qualified persons in order toavoid a hazard.
WARNING---- Do not damage the refrigerant circuit.
WARNING---Do not use electrical appliances inside the food storage compartments of
appliance,unless they are of the type recommended by the manufacturer.
MAINTENANCE
Remove power plug or disconnect from the mains before performing any maintenance or servicing
the product.
Never use detergent or chemicals harmful to health to clean the water tanks.
Do not directly spray water on the surface of the product.
Wipe the front and back of the product with water-soaked soft cloth.
If dust of other exterior substance has accumulated on the condenser, wipe off with water-soaked
soft cloth.
After cleaning the product, completely dry it. Fill the water to the tanks until waters comes out of
the hot water faucet, then connect the electric power plug. If the surface of the electric heater in
the hot water tank is deposited by water deposition, heating capacity will decrease. Fill hot water
tank with aqueous solution of 2% aitric acid and keep for about two hours then cleaning. If the
problems can not be solved, contact your dealer or the Service Center of our company.
