LIMIT BLOCK LOCATION
Installing the limit blocks and adjusting the limit switches is most easily done after the case has been
mounted and before the drive is placed into the case / enclosure. Final adjusting the stop blocks
should be done with the gate powered by the operator.
Limit Blocks
Left Limit Block
Right Limit Block
SPECIFICATION:
Without slow stop.
Left hand operation is shown. Switch the words open and close for right hand operation.
1.
Once installation is complete, set the slow dip switch down on the control board to the
off position.
2.
Move the gate to its fully closed
position and make a vertical line on the
rail at the left edge of the enclosure.
Note: these instructions are based on a
medium weight gate travelling on a flat
surface. Inclines, variations in weight as
well as variations in rolling resistance
can substantially affect the coasting
distance of the gate. In instances
where the conditions differ substantially
it is recommended to run the gate near
the fully open and fully closed point to
determine the coasting distance. Run
12
