RAIL LOCATION REQUIREMENTS
RAIL SPECIFICATION:
Dimensions for the web are based on using a 4” x 4” x 1/4”
thick “Angle Iron” or equivalent with a 4” web section
intended as the contact area for the drive wheels of the ALL
SECURE unit.
1.
The contact web of the drive rail must extend no less
than 4 inches from the gate for clearance.
2.
Web sections, transitional radii, welds, and gussets
musts not extend more than 1 1/2” from the face of
the gate to avoid interference with the ALL SECURE
casing.
3.
The Ideal height for the rail is 9 3/4” from the
underside of the drive rail to the top surface of the
ALL SECURE mounting pad.
RAIL PLACEMENT:
1.
Clamp or otherwise secure the rail in the position
shown in Figure 2 with the bottom of the rail lining
up as shown.
2.
Repeat this process in at least three separate
locations along the rail as it is attached to the
gate to ensure the rail is within tolerance along
the entire travel length of the gate.
3.
Once the rail is in the correct position weld or
otherwise attach the rail to the gate as required
checking to be sure no attachment welds or
hardware interfere with the rail path.
4.
If any problems in this process occur, please call
RAMSET customer service immediately.
10
