RAMMER 2155E, Operator'S Manual

Page: 24 / 80

COPYRIGHT © 2019 SANDVIK MINING AND CONSTRUCTION OY Page 24 - Operation
Safety 2155E STD
LABELS ON THE PRODUCT
Safety labels communicate the following four things:
■
The severity level of the risk (that is, signal word "DANGER" or
"WARNING").
■
The nature of the hazard (such as high pressure, or dust).
■
The consequence of interaction with the hazard.
■
How to avoid the hazard.
You must ALWAYS follow the instructions of the safety messages and symbols of
the product safety labels and the instructions set forth in the manuals to avoid death
or severe injury!
Keep the safety labels clean and visible at all times. Check the condition of safety
labels daily. Safety labels and instructions which have disappeared, been damaged,
painted over, come loose or do not meet the legibility requirements for safe viewing
distance, must be replaced before operating the product.
If a safety label is attached to a part that is replaced, install a new safety label on the
replacement part. If this manual is available in your language, then the safety labels
should be available in the same language.
There are several specific safety labels on this hammer. Please become familiarized
with all safety labels. The location of the safety labels is shown in the illustration
below.
When you clean the safety labels, use a cloth, water and soap. Do not use solvent,
gasoline or other harsh chemicals to clean the safety labels.
Solvents, gasoline or harsh chemicals could loosen the adhesive that secures the
safety labels. Loose adhesive will allow the safety label to fall.