RAMFAN R2C-5500AC, Owner'S Manual

Page: 5 / 12

5
Electrical Connections
Installation continued
Charging Status
The charger will examine
connected batteries’ voltage
GREEN FLASHING
RED
ORANGE RED FLASHING
GREEN
Indicator Lights During Charge:
SOLID GREEN
Battery pack voltage above 40VDC
Battery pack fully charged
1 SEC GREEN
FLASH
Battery pack is between 38
and 40VDC
SOLID ORANGE
Battery pack is between 33
and 38VDC
1 SEC RED FLASH
Battery pack between 27
and 33VDC
SOLID RED Battery pack voltage below 27VDC
½ SEC RED FLASH
Battery pack failed to charge in 9
hours, or Battery pack less than
6VDC
OFF
No AC or DC input power or no
battery pack
Route and attach AC power cable plug to appropriate AC power receptacle, or route and
attach DC power cable to an appropriate 12V DC or 24V DC power block.
Three models to support various input power application: 85-260V with NEMA plug,
85-260V with Schuko plug, and 12-24DC.
AC Models: Insert AC plug into the appropriate AC power receptacle. The AC input battery
charger models are built around a universal (85 - 260AC, 50 / 60Hz) input power supply.
Only the AC plug determines the input voltage to be 115VAC or 230VAC.
DC Models: Will work with 10-30VDC input.
Charger is not equipped with a power switch and there is no reason to cycle power ON &
OFF.
Charger automatically turns ON when input power is applied to the charger. Both Battery
status LEDS will flash at a rate of two flashes per second for 10 seconds and then turn OFF
until battery pack(s) have been connected to charger.
•
Determine appropriate through hole drill bit for select screws
•
Drill four holes at indicated mounting locations, on the drill template and tap holes if
required
•
Install screws with screw head about 1/8
"
above mounting surfaces
•
Hang charger onto the four screws
•
Tighten screws to securely hold charger in place
Batteries should not be stored for longer than 12 months without charging, to maintain
“longterm reliability.”
Refer to pages 8 and 9 for Drill Template illustration