CAUTION!
Failure to follow these procedures could result in
damage to the charging system of the booster vehicle
or the discharged vehicle.
Connecting The Jumper Cables
1. Connect the positive
(+)
end of the jumper cable to the
remote positive
(+)
post of the discharged vehicle.
NOTE:
The remote positive
(+)
post is located in the
engine compartment on the driver’s side under the cover
of the Front Power Distribution Center.
2. Connect the opposite end of the positive
(+)
jumper
cable to the positive
(+)
post of the booster battery.
3. Connect the negative end
(-)
of the jumper cable to the
negative
(-)
post of the booster battery.
4. Connect the opposite end of the negative
(-)
jumper
cable to the remote negative
(-)
post of the discharged
vehicle.
NOTE:
The remote negative
(-)
post is located in the
front of the engine compartment on the driver’s side.
WARNING!
Do not connect the jumper cable to the negative (-)
post of the discharged battery. The resulting electri-
cal spark could cause the battery to explode and
could result in personal injury. Only use the specific
ground point, do not use any other exposed metal
parts.
5. Start the engine in the vehicle that has the booster
battery. Let the engine idle a few minutes and then
start the engine in the vehicle with the discharged
battery.
6
WHAT TO DO IN EMERGENCIES
305
Summary of Contents for 2014 RAM PROMASTER
