Raisecom
RC1104-FE-4W (A) User Manual
3 Preparing for installation and connecting cables
Raisecom Technology Co., Ltd.
5
3.2 Verifying cable type
0.4 mm (American standard 26 AWG)/0.5 mm/0.6 mm telephone wire
3.3 Connecting to other device (G.SHDSL interface)
Requirements are as below:
STU-C and STU-R are configured in pair.
The rate should be configured in the same range.
The Annex mode should be the same.
The PAM mode should be the same.
The Tx power should match (the standard G.SHDSL supports auto-negotiation).
When remote network management is used, the local device and remote device should
be configured to master and slave modes respectively.
3.4 Connecting to the same device
When the RC1104-FE-4W series devices are interconnected with each other, the following
requirements on models should be met. Otherwise, the link is disconnected or the data are
transmitted improperly.
Figure 3-2
Point-to-point networking with the RC1104-FE-4W
Table 3-2
Device models on both local and remote ends
Local end
Remote end
RC1104-FE-4W
RC1104-FE-4W
Figure 3-3
RC1104-FE-4Wworking as the remote end of the RC1108-SHDSL-2W×8
