33
Disassembly Instructions
Removing the Control Head
• Disconnect the power cord from the back of the control and place the
system on bypass.
• Remove the rear cover and depress the brine stem to relieve the water
pressure (
see Figure 16
).
• Remove the piston guide screw and the control head mounting screws
(
see Figure 16
).
• Reverse the procedure for reassembly. To ensure alignment with the
cam shaft, make sure the piston is all the way up (
see Figure 18
).
!
Important Note: Be careful not to pull on
the flow sensor cable; it may damage the
computer board. If you need to
completely remove the control head
from the valve, remove the flow sensor
cable from the flowmeter housing.
CONTROL MOUNTING SCREWS
PISTON GUIDE
SCREW W/ WASHER
BRINE STEM
Figure 16
FLOW METER CABLE
Figure 17
PISTON POSITIONED
ALL THE WAY UP
Figure 18
Summary of Contents for EC5 Series
Page 22: ...22 Control Exploded View 1 5 3 4 4 6 11 7 8 8 10 9 14 2 15 12 13...
Page 42: ...Notes...
Page 43: ...43 Notes...
