7. Wire tie the antenna cable to the pole. Clean up the wire ties and put the cable cover back
on.
8. Refer to the NL241 user manual for setting information to establish communications
https://s.campbellsci.com/documents/us/manuals/nl241.pdf
).
6.8 Lightning rod installation
Install lightning rod as shown in
1. Carefully mount the lightning rod clamp to the top of the pole (
(p. 57)).
Position the clamp so it won’t interfere with the connector cover.
FIGURE 6-40. Lightning rod bracket installation
2. Strip 2.5 cm (1 in) from the top of the main green 10 AWG pole ground wire.
3. Insert the exposed wire into the empty clamp opening. Do not tighten the screw at this
time (
(p. 58)).
Section 6. Installation
57
Summary of Contents for WS-PRO2
Page 9: ...FIGURE 3 4 WS PRO2 bottom layer Section 3 Initial inspection 5...
Page 113: ......