FIGURE C-7. Enclosure mounted on WS-PRO2 pole
6. The bottom enclosure bracket has a small metal locking mechanism. Push up on the small
Phillips screw underneath the mechanism and slide it to the left. Once in place, put a small
wire tie in the hole to the right of the locking mechanism (
(p. 97)).
NOTE:
To remove the enclosure from the bracketing, cut off the wire tie, slide the lock to the
right, and lift the entire enclosure off the bracketing.
Appendix C. PS24 24 Ah power supply with 10 x 12 inch enclosure
96
Summary of Contents for WS-PRO2
Page 9: ...FIGURE 3 4 WS PRO2 bottom layer Section 3 Initial inspection 5...
Page 113: ......