GB
PROGRAMMING
F. PROGRAM TRANSMISSION,
REVIEW, AND CHANGE
20
1. PROGRAM TRANSMISSION
1.1 Plug the field transmitter optical connector onto the control
module. If the LCD screen is blank, press the key.
1.2 - If you have not already done so, enter the program data.
1.3 - Press .
1.4 - After transmission is correctly completed, the
transmitter will display this screen.
1.5 Press to remove the display
1.6 - Unplug the field transmitter optical connector from the
control module. The module will now automatically operate.
Important :
if the blinking low battery icon is displayed on
the LCD during program transmission, replace the 9V battery
in the TBOS control module. The low battery icon is used
only in control modules marked TBOS.
NOTE :
Make sure the optical connectors are clean and properly
connected to each other. The control module must be equipped
with a fully charged 9V Alkaline battery (Ref. 6LR61).
2. PROGRAM REVIEW AND CHANGE
2.1 - Plug the field transmitter optical connector onto the
control module.
2.2 - If the LCD screen is blank, press the
➞
key.
2.3 - Press the key to receive the program data
stored in the control module. You can now review the program
that is in the control module : run time, start times, water
days, station program assignment (A,B,C), "ON/OFF". However,
you cannot consult the current time of day stored in the module.
2.4 - To modify the program data, simply enter the desired
modifications. Press the key even if you decide
not to make any changes. This will synchronize the transmitter
and module clocks.
Important:
if the blinking low battery icon is displayed on
the LCD during program reception, replace the 9V battery
in the TBOS control module. The low battery icon is used
only in control modules marked TBOS.
TBOS IR Anglais new der 5/11/04 15:20 Page 8
