GB
21
G. MANUAL FUNCTIONS
Important !
The next 3 functions override all others.
This means that any program currently running will be suspended
to permit the use of the manual functions.
Before carrying out a manual start, make sure a run time
(at least 1 minute) has been programmed and transmitted
to the control module and that the control module is in the
irrigation "ON" mode (no X on the sprinkler).
1. MANUAL SINGLE STATION START.
1.1 Plug the field transmitter optical connector
onto the control module.
1.2 Repeatedly press the key until the following
screen is displayed.
The station number appears at the left.
(Example : station 1).
1.3 Repeatedly press the
key until the desired station
number appears.
1.4 To start a station, press the +/ON key. Irrigation will
start after 2 seconds (after 10 seconds for Unik modules
and after 20 seconds for old style Unik modules). See page
the first page of this manual for drawings of the modules.
If you wish to stop watering before the programmed time
is up, press the -/OFF key.
2. MANUAL CYCLE START.
Remember that a cycle consists of all stations operating in
sequential order.
2.1 Plug the field transmitter optical connector into the control
module
2.2 Repeatedly press the
key until the screen
below is displayed.
2.3 Select the program cycle you wish to start with the ABC
key.
2.4 Your selection is displayed as “Prog A”, “Prog B” or “Prog C”.
STA
CYC
TBOS IR Anglais new der 5/11/04 15:20 Page 9
