Oslostrasse 5, CH
–
4023 Basel
Tel. +41 [0]61 333 70 33, Fax +41 [0]61 333 70 32
www.easyrain.net [email protected]
Brunner Bewässerung - Arrosage
Gebrauchsanweisung Steuerung ESP-TM
15
ESP-TM controllers are designed for indoor mounting
only. For best results, mount the controller at eye level.
Mount the controller so that a 117-Volt AC power outlet
is within five feet of the controller so the wires from the
external transformer can be easily connected to the
controller.
Select Location
INSTALLING THE CONTROLLER
The ESP-TM controller has three "keyhole" slots on
the back of the cabinet. Use these slots to mount the
controller to a flat wall or vertical stud. Always use
lower mounting hole "D" to secure the bottom of the
controller.
ESP-TM Installation and Operation
Page 27
Mount Controller
1
2
Place the supplied mounting template in the desired
location on the wall. Mark the screw center locations by
punching through the template with a sharp tool.
Remove the template. Two plastic spacers are provided
for the upper mounting screws only. (See illustration on
the next page.)
Slip the spacers over the screws and drive them into the
wall or stud at the upper keyhole marks: holes A and C
for flat surfaces, or hole B only for an exposed stud.
When the wide, flat end of the spacer is pressed against
the wall or stud, the screw is at the proper depth. Do
NOT
drive a fastener into location D at this time.
Remove the controller's lower face panel by gently prying
out the panel at the slots on the left and right sides.
Hang the controller on the upper keyhole slots.
Make
sure
the spacers are in the upper, narrow portion of the slots.
Then drive a fastener through lower mounting hole D. The
controller should
now be secure.
3
4
ESP-TM Installation and Operation
Page 28
All manuals and user guides at all-guides.com