mod. BULLDOG ADV - eD. 03/2014 - s. 04
© Raimondi S.p.a.
Chapter 4
Use of the commands
Page 28/44-4
machines & tools for the tile & stone professional
Polishing phase
Suitable for polishing edges up to 30 mm (1
3/16”
)
thick.
To keep the belt in good working order:
1)
Adjust the position of the diamond belt for complete (but minimal) contact with the edge.
2)
The amount of material removed should not exceed 1/100 of mm (0,00004 inches).
3)
Cooling water must be clean. Suspended dust resulting from the operations previously performed may damage the
diamond belt.
4)
The belt operating cycle is the following: 400 grain; 800 grain.
5)
Final polishing with a 800 grain belt can only be performed after pre-polishing with a 400 grain belt.
6)
Use of the belt
in fixed position can lead to uneven wear of the diamond rib and streaking on its surface. To prevent this
inconvenience occurring, change the position of the belt
(see paragraph “4.2 Adjusting the 45° grinding wheel for jolly
cuts/ bevelling”)
.
BEFOrE POLIShING, IT IS ESSENTIAL TO PErFOrM ThE GrIND-ING/POLIShING OPErATIONS.
