Bulldog ADV
Chapter 4
Use of the commands
© Raimondi S.p.a.
Via dei Tipografi, 11 - 41122 Modena (Italia)
Tel.: +39.059.280.888 - Fax: +39.059.282.808
www.raimondiutensili.it - e-mail: [email protected]
Use and Maintenance Manual
Page 21/44-4
4.3 Blocking of material
TO CArrY OUT ThIS OPErATION, MAKE SUrE ThE MAChINE IS NOT CONNECTED TO ThE MAINS.
Materials with a width ranging from 100 mm (3 1
5/16”
) to 200 mm (7
7/8”
)
The machine is equipped with no.1 trolley (
A
), no.4 long guides (
B
) and
no.1 pressing device (
C
).
B
A
The standard trolley consists of no. 4 short guides, no. 1 aluminum black square, no. 1 steel square, no. 1 support, no. 5
movable clamps, and it is set for automatic driving.
The trolley works a corner having a maximum length of 800 mm (31
1/2”
) and a width determined by the following configurations:
- width ranging from 100 mm (3
15/16”
) to 200 mm (7
7/8”
) with short or long guides and black square;
- width ranging from 70 mm (2
49/64”
) to 100 mm (3
15/16”
) with short or long guides and steel square;
- width ranging from 45 mm (1
25/32”
) to 70 mm (2
49/64”
) with short or long guides, steel square and pressing device;
- width ranging from 200 mm (7
7/8”
) to 600 mm (24”) with long guides and black square.
AUTOMATIC DrIVING CANNOT BE USED FOr SIZES BIGGEr ThAN 400 MM (16”); ThE MATErIAL MUST
BE CArrIED AND PUShED BY hAND.
MAKE SUrE ThAT ThE SIDE OF MATErIAL rESTED AGAINST
ThE SLIDE (D) IS STrAIGhT AND DOES NOT ShOW ANY
IrrEGULArITY.
D
Position the material to be shaped onto the trolley perfectly rested against the frame slide (
E
) and against the rear support
(
F
) of trolley. In order to prevent the material from shifting, draw the black square (
G
) near it and lock it by knobs (
h
).
G
E
F
h
C
