Bulldog ADV
Chapter 4
Use of the commands
© Raimondi S.p.a.
Via dei Tipografi, 11 - 41122 Modena (Italia)
Tel.: +39.059.280.888 - Fax: +39.059.282.808
www.raimondiutensili.it - e-mail: [email protected]
Use and Maintenance Manual
Page 25/44-4
WhEN ShAPING, BEAr IN MIND ThE INSTrUCTIONS GIVEN IN ThE “WORKSTATION PArAGrAPh”
(see paragraph 2.6).
BEFOrE PrOFILING, MAKE SUrE ThAT ThE GrINDING WhEEL IS ShArP, PLACED IN ThE COrrECT
POSITION AND ThAT ThE MATErIAL hAS BEEN PrOPErLY BLOCKED.
BEFOrE PrOFILING, MAKE SUrE ThE KNOB AND ThE hANDLE ON ThE TrOLLEY hAVE BEEN
PrOPErLY FIXED.
ThE FEEDING SPEED DUrING ThE PrOFILING ShALL BE PrOPOrTIONAL TO ThE hArDNESS AND
ThICKNESS OF ThE MATErIAL TO BE PrOFILED TO PrEVENT ThE MATErIAL FrOM DISPLACING AND
TO AVOID A MOTOr OVErLOAD.
IF ThE PrOFILING PErFOrMANCE IS UNSATISFACTOrY , DESPITE ThE COMPLIANCE WITh ALL ThE ABOVE-
LISTED PrOCEDUrES, IT IS NECESSArY TO ChECK ThE CLAMPS TIGhTNESS AND TO DrESS ThE GrINDING
WhEEL BY MEANS OF ThE DrESSING STONE.
AFTEr YOUr WOrK AND BEFOrE DISENGAGING ThE PIECE FrOM ThE CLAMPS, TUrN OFF ThE
MAChINE BY MEANS OF ThE POWEr SWITCh.
4.4 Comply with the following warnings for all profiling types
