Bulldog ADV
Chapter 4
Use of the commands
© Raimondi S.p.a.
Via dei Tipografi, 11 - 41122 Modena (Italia)
Tel.: +39.059.280.888 - Fax: +39.059.282.808
www.raimondiutensili.it - e-mail: [email protected]
Use and Maintenance Manual
Page 27/44-4
Finishing phase
Suitable for finishing edges up to 30 mm (1
3/16”
)
thick.
To finish the edge previously machined with the grinding wheel for removal:
1)
Fit the 100 grain diamond belt on the rubber expander.
2)
Adjust the position of the belt to obtain minimal contact with the edge.
3)
The amount of material removed should not exceed 2/10 of mm (0,008 inches).
4)
Use of the belt
in fixed position can lead to uneven wear of the diamond rib and streaking on its surface.
To prevent this inconvenience occurring, change the position of the belt.
4.6 Performing Jolly cuts (mitering 45°) and bevelling
removal phase
Suitable for Jolly cutting (mitering 45°) and bevelling
1)
Adjust the position of the grinding wheel according to the quantity of material to remove.
2)
If the material is very hard or thick, repeat the shaping in 2 or 3 passes.
3)
Use of the grinding wheel in fixed position can lead to uneven wear of the diamond rib and streaking on its surface.
To prevent this inconvenience occurring, change the position of the grinding wheel.
4.7 Grinding edges
removal / Grinding phase
Suitable for removing / grinding edges up to 30 mm (1
3/16”
) thick.
1)
Adjust the position of the grinding wheel according to the quantity of material to remove.
2)
If the material is very hard or thick, repeat the shaping in 2 or 3 passes.
3)
Use of the grinding wheel in fixed position can lead to uneven wear of the diamond rib and streaking on its surface.
To prevent this inconvenience occurring, change the position of the grinding wheel.
