mod. BIBULLDOG ADV
© Raimondi S.p.a.
machines & tools for the tile & stone professional
Chapter 3
Handling, installation, adjustments
Page 18/44-3
After closing the drain hole with the specific plug, pour cold and clean
water into the tank until a level 2 cm (3/4”) above the recycle pump
has been reached.
3.4.2 Tank filling
TO CARRY OUT THIS OPERATION, MAKE SURE THE MACHINE IS NOT CONNECTED TO THE MAINS.
Recycle
pump
TO ALLOW FOR THE PUMP CORRECT FUNCTIONING, WATER SHALL BE KEPT CLEAN.
EACH TIME THE TANK WATER IS CHANGED
,
CLEAN THE FILTER AND THE PUMP IMPELLER.
POUR IN ENOUGH CLEAN WATER TO COVER THE PUMP.
Water level
Tank
Recycle
pump
Min. 2 cm
Min. 3/4”
3.4.1 Extensions for sliding plane
Remove the trolley from the machine. Approach extensions to the frame, fit screws (
A
) into their housigns and clamp not
completely the nuts. Mount on the extensions the supporting legs (
D
) and completely tighten screws (
E
).
To find levelness between the machine plane and the extension plane use a scale and adjust the feet. Fit the trolleys on
guides. Position the striking plate (
G
) on the trolley plane and after checking it is leaning on the guide (
C
) of the machine clamp
by emans of clamps (
H
). Perfect the positioning of the extension so that by sliding the trolley the striking plate (
G
) keeps in
contact with guides (
C
) of the machine and of the extensions.
Once the correct position is found clamp deeply the screws (
A
). Check for the correct assembly by sliding the trolley
completely.
In case the trolley cannot slide loosen the screws (
A
) and repeat the above operations.
E
D
B
C
B
C
A
A
A
E
G
C
H
H
