Raider RDI-EBV06, User Manual

Page: 11 / 80

11
Operating modes
Blowing
For operation mode “blowing”, firmly attach the nozzle in alignment with the arrow mark onto the
air intake.
Vacuuming
- For operation mode “vacuuming, firmly attach the nozzle in alignment with the arrow mark
onto the air intake.
- Additionally, always mount the dust bag onto the air outlet.
Working Advice
During “blowing” operation, take care that no debris/impurities can be drawn into the air intake.
Never vacuum without a dust bag.
Do not vacuum sharp-edged or hot materials, such as glass splinters, hot ash or metal chips.
When vacuuming, empty the dust bag regularly. Observe the environmental regulations when
disposing waste.
Replacing the Carbon brushes
Check the length of the carbon brushes and replace the carbon brushes if required.
Never replace only a single carbon brush.
Maintenance and cleaning
• Before any work on the machine itself, pull the mains plug.
• For safe and proper working, always keep the machine and ventilation slots clean.
If the machine should fail despite the care taken in manufacturing and testing procedures, repair
should be carried out by an after-sales service centre.
If the replacement of the supply cord is necessary, this has to be done by authorized service in
order to avoid a safety hazard.
• Preservation of the environment.
In view of environmental power, additional accessories and packaging must be subjected to
appropriate processing for reuse of the information contained in these materials.
Do not dispose of electric household waste! Under the EU Directive 2012/19/EC on waste electrical
and electronic devices and validation and as a national law power which can be used more, must be
collected separately and be subjected to appropriate processing for recovery of contained they scrap.