TROUBLESHOOTING
8 - 2
8.1 Special
Diagnostic
Mode
To place the monitor into the special diagnostic mode, first turn
the monitor off. Next push and hold the
[Y/+]
key, while still
holding the
[Y/+]
key, also push and hold the
[MODE]
key for
at least two seconds. After the required delay, release both
keys, the monitor will now go through the normal start-up
display sequence and display a “Diagnostic mode” message. At
the end of the special mode start-up, the display will show the
raw counts of sensor channel 1A. These numbers are raw
sensor readings without calibration.
Other critical parameters of the monitor are available as shown
below. They can be reached by pressing the
[MODE]
key
repeatedly until the desired parameters are displayed.
