ToxiRAE Pro User’s Guide
27
Settings are available for:
•
Off/On
•
Motionless Time (time the instrument is motionless before initiating a pre-alarm)
•
Sensitivity (set to low, medium, or high to compensate for ambient vibration or motion)
•
Warning Time (countdown, in seconds, from pre-alarm to Man Down alarm)
When the Man Down alarm is activated, the buzzer sounds and LEDs flash continuously, and a
countdown begins.
•
If the
ToxiRAE Pro
’s user presses [Y/+] for “Yes” in response to the “Are You OK?”
question on the screen before the countdown reaches zero, the Man Down alarm stops
and the main reading screen is displayed.
•
If the person does not press [Y/+] for “Yes” in response to the “Are You OK?”
question on the screen before the countdown reaches zero, the Man Down alarm is
sounded and LEDs flash continuously.
•
If the person presses [MODE] during the countdown, answering the “Are You OK?”
question with “No,” the Man Down alarm starts.
If the ToxiRAE Pro’s wireless connectivity is enabled, a Man Down message is also sent to
remote observers.
Exit (the Alarm Settings Submenu)
Press [Y/+] to exit the Alarm Settings submenu. Alarm Settings is exited, and Datalog is
highlighted.
If you want to cycle through the Alarm Setting submenus, press [MODE] instead of [Y/+].
Exit (the Alarm Settings Submenu)
Press [Y/+] to exit the Alarm Settings submenu. Alarm Settings is exited, and Datalog is
highlighted.
If you want to cycle through the Alarm Setting submenus, press [MODE] instead of [Y/+].
12.5.3. Datalog
Clear Datalog
This operation erases all data stored in the datalog.
Note:
Once the datalog is cleared, the data cannot be recovered.
Press [Y/+] to clear the datalog. The display asks, “Are you sure?”
•
Press [Y/+] if you want to clear the datalog. When it has been cleared, the display
shows “Datalog Cleared!”
•
Press [MODE] if you do not want to clear the datalog.
