OPERATION
2 - 14
8)
The
run time
reading is the accumulated “On” time in
hours and minutes since the monitor was turned on.
The reading is updated at one-minute intervals and is
shown in the LCD display together with the current
date, time and temperature.
8/3/96
8:30
On = 3:50 20
°
C
9) The
datalog
menu shows the current datalog mode. If
manual datalog mode is selected, the menu will prompt
the user to turn on or off datalogging. Pressing the
[Y/+]
key while the “Start Datalog?” message is
displayed turns on the datalogging. Likewise, pressing
the
[Y/+]
key while “Stop Datalog?” message is
displayed turns off the datalogging.
10) The monitor will display the selected
LEL gas name
if
the combustible sensor is installed. When the selected
LEL gas is different than the calibration gas, a
programmed correction factor for that specific gas is
multiplied by the readings and the corrected gas
concentrations are displayed.
11)
Print Reading?
allows printing the gas concentration
readings. If a serial printer is connected and ready,
press
[Y/+]
to print the readings. This function is shown
only when enabled; the default setting is disabled and
the display is not shown.
Summary of Contents for Q-RAE
