Radyne DMDVB20 LBST, Installation And Operation Manual

Page: 60 / 113

User Interfaces DMDVB20 LBST Satellite Modem
4-24 TM138 – Rev. 1.0
The IP Address Mask of the local network. The mask is
expressed in a hexadecimal format, and must be a valid
TCP/IP Mask. This field should be set before changes
are made to the Modem or Router Address.
MODEM IP ADDR {XXX.XXX.XXX.XXX} Hexadecimal Address
{ddd.ddd.ddd.ddd} Decimal Mask
The IP Address of the modem. This address should be
consistent for the mask defined. This address is
expressed in hexadecimal format. Broadcast and loop
back addresses will not be allowed. These are
addresses with all subnet bits set to 0’s or 1’s.
ROUTER IP ADDR {XXX.XXX.XXX.XXX} Hexadecimal Address
{ddd.ddd.ddd.ddd} Decimal Address
The IP Address of the Local Network Router. If a router
is present on the local network, this address must be
consistent with the IP Mask and the subnet of the
modem. If no router is present, then the address should
be set to a foreign address. This address is expressed
in hexadecimal format.
BOOTP SERVER {XXX.XXX.XXX.XXX} Hexadecimal Address
{ddd.ddd.ddd.ddd} Decimal Address
The IP Address of the Boot Server and the address of
the SNMP Trap Server when SNMP is active. If a server
is used and there is no local router, this address must be
consistent with the modem address. If a router has been
specified, the address is presumed to be reachable via
the router. Broadcast and loop back addresses will not
be allowed. These are addresses with all subnet bits set
to 0’s or 1’s.
Broadcast and loop back addresses will not be allowed.
These are addresses with all subnet bits set to 0’s or 1’s.
To change the display for the IP ADDRESS MASK, MODEM IP ADDRESS,
SERVER IP ADDRESS, AND ROUTER IP ADDRESS, press all four arrow
keys simultaneously.
MODEM EADDR {001065010000}
Displays the Ethernet address of the device. Set at the
factory and is a unique identifier for the Ethernet physical
interface.
ETHER
RATE {10 MBPS/HD}
The data rate for the local Ethernet Interface.