RADVision Scopia Elite 6000 Series, Installation Manual

Page: 16 / 50

Use switched video only when all endpoints participating in the videoconference support the
same resolution. If a network experiences high packet loss, switched video might not be
displayed properly for all endpoints in the videoconference.
Note
You cannot combine the increased capacities of video switching with lower resolution or
frame rate. The two methods of increasing capacity are mutually exclusive.
You can also remove video completely and create an audio-only meeting type to further
increase capacity.
Capacity is measured in terms of ports, where a port is typically a single participant's
connection to a videoconference.
The number of ports available with switched video and audio only is listed in
Table 2-2 on
page 12 .
Table 2-2 Port capacity with switched video
Scopia Elite 6000 Series MCU Model Maximum quality
(1080p at 60fps)
no switching Switched Video
(x4) Audio Only
(x8)
Scopia Elite MCU 6105 3 ports 10 ports 20 ports
Scopia Elite MCU 6110 5 ports 20 ports 40 ports
Scopia Elite MCU 6120 10 ports 40 ports 80 ports
Scopia Elite MCU 6140 20 ports 80 ports 160 ports
For more information about enabling video switching on a meeting type (MCU service), see
Administrator Guide for Scopia Elite MCU 6000 Series.
Ports to Open for the Scopia Elite 6000 Series MCU
The Scopia Elite 6000 Series MCU is typically located in the enterprise network and is
connected to the DMZ. When opening ports on the Scopia Elite MCU, use the following as a
reference:
•
If you are opening ports that are both in and out of the Scopia Elite 6000 Series MCU, see
Table 2-3 on page 13 .
•
If you are opening ports inbound to the Scopia Elite 6000 Series MCU, see Table 2-4 on
page 14 .
Note
The specific firewalls you need to open ports on depends on where your MCU and other Scopia
Solution products are deployed.
RADVISION | Installation Guide for Scopia Elite 6000 Series MCU Version 8.0 Planning your MCU Deployment | 12