19
EN
G
LIS
H
SAT-Receiver 1
UniCable LNB
SPS 6921
SAT-Receiver 2
Setting the UniCable LNB
a
. Adjust direction of Dish antenna to the favorite
satellite.
b
. Connect
UniCable LNB
to the dish antenna.
c
. Connect
UniCable LNB
with a splitter and than,
splitter with LNB inputs of two separated receivers.
d
. After all connections are well done, please turn on
one of receivers for software setting.
e
. Select IF frequency using the
Arrow (◄/►)
buttons.
f
. After selection of IF frequency, IF channel will be
saved by pressing the
BACK
or
EXIT
button.
g
. Each receiver connected to
UniCable LNB
must use
different IF channels.
h
. After the setting completes, please switch it off for
the connection to other receivers. Setting process is
same as the above way.
9
. Set the
22KHz
Tone.
In case you are using a Dual LNB or two antennas
connected to a 22KHz tone switch box, make 22KHz
tone
ON
or
OFF
to select LNB or antenna.
■
ON:
Select
ON
if Dual LNB is used or 2 antennas are
connected to the 22KHz tone switch box.
■
OFF:
Select
OFF
if 22KHz Tone is not used.
10
. Set the
DiSEqC
Input switch.
DiSEqC must be used when using two or more antennas
and LNBs.
Select
None
,
DiSEqC 1.0
,
DiSEqC 1.1
,
Motor
and
USALS
using the
Arrow(◄/►)
buttons.
11
.
Committed
Sets the port number of
DiSEqC 1.0
switch (1 to 4) using
the
Arrow(◄/►)
buttons.
12
.
UnCommitted
Sets the port number of
DiSEqC 1.1
switch (1 to 16)
using the
Arrow(◄/►)
buttons.
13
. After the setup is complete, press the
RED
button to
save.
Adjusting Initial Settings and Operations
Radix_Eng.indd 19
2006-09-15 ｿﾀﾀ・11:37:53
