RadioRA Setup Guide Addendum
ALL ON
ALL OFF
ROOM Programming
GRAFIK Eye Scene Selection for ROOM Buttons
Note: Programming the light levels of GRAFIK Eye Control Unit scenes should be done prior to this step and in
accordance with the GRAFIK Eye Installer's Guide.
Step 1
Begin GRAFIK Eye scene
selection
MASTER BR
LIVING RM
FOYER
FAMILY
DEN
DINING
READING
MORNING
NIGHT
MOVIE
PATIO
FR. PORCH
GARAGE
BASEMENT
LAUNDRY
ALL ON
ALL OFF
1-5
Section 1 - Start-Up
Table Top Master
Wall Master
OR
Step 3
Select a GRAFIK Eye scene
Simultaneously press and hold the 1st and 5th
buttons in the right most column until the
upper right LED begins to blink (approximately
3 seconds).
Note: If the GRAFIK Eye Control Unit has been
assigned an address (A1-A8), pre-programmed
scenes 5 through 16 may be selected by putting the
GRAFIK Eye Control Unit into setup mode and
recalling the desired scene. (Refer to the GRAFIK Eye
Installer's Guide for required steps.) The GRAFIK Eye
Control Unit should remain in setup mode until Step 5
of this section is completed.
Upper right LED blinks.
MASTER BR
LIVING RM
FOYER
FAMILY
DEN
DINING
READING
MORNING
NIGHT
MOVIE
PATIO
FR. PORCH
GARAGE
BASEMENT
LAUNDRY
ALL ON
ALL OFF
GRAFIK Eye Control Units that have been
assigned to that button will turn ON to scene 1.
MASTER BR
LIVING RM
FOYER
FAMILY
DEN
DINING
READING
MORNING
NIGHT
MOVIE
PATIO
FR. PORCH
GARAGE
BASEMENT
LAUNDRY
ALL ON
ALL OFF
SCENES
ROOMS
ROOMS
Step 2
Select a ROOM button
Press and release the ROOM button that you
want to program. Its LED will begin to blink.
At the GRAFIK Eye Control Unit, select one of
the pre-programmed scenes (1 through 4) by
turning that scene ON.
LUTRON
The GRAFIK Eye Control Unit will turn ON to
the scene selected in this step when the ROOM
button is pushed. The last scene selected on
the GRAFIK Eye Control Unit will be the scene
programmed to the ROOM button.
