K2015 Alarm Modules and Relay Outputs
_______________________________
K2100/K1100 User Guide
_______________________________
74-07069-000-B 3/94
Page 61
© 1994 Radionics, Inc.
Present an editor key to the front panel reader.
Enter the password and press ENT, if required.
You will now see the
prompt.
Type
and press ENT.
Use the up and down arrow keys to select a response.
There are a maximum of 255 responses.
Manual Switch
Press Y to switch on the response. Press ENT.
Press N to switch off the response. Press ENT.
Note:
Any points that have been assigned this response
will be disabled if you select N, or enabled if you select Y.
Press
NXT
to go to the next field.
Time Profile
Enter the Time Profile number used to control the
response. When the Time Profile is active, any points
assigned this response will be disabled.
A Time Profile of zero means any points assigned this
response will be controlled only by the Manual Switch.
Press ENT
Press ESC to return to the
prompt.
Alarm Module Sensors - The MS Command
Each Alarm Module input is enabled by giving it a response number, see the MR
command above. In addition, each input may be programmed to operate a relay on any
Alarm Module
on the same door controller.
Response Number
By giving one or more inputs the same response number, several points can be controlled
together. The number you enter is the record number of the response you create using the
MR command.
Module Relay
Any Alarm Module Relay on the same door controller can be set when a point is activated.
The number you enter is the number of the relay according to the table below:
Module Location
Relays
Channel 1
1
2
3
4
Channel 2
5
6
7
8
Channel 3 *
9 10 11 12
Channel 4 *
13 14 15 n/a
* Not available on K1100 door controllers
Note:
The fourth relay on Module 4 is not available for Alarm Input activation.
The MS Command
Use the MS command to assign responses to Alarm Module inputs. Each record contains
responses for all 8 inputs on each Alarm Module
