Radiolink Electronic Limited
17
/
17
Thai is, 1-A,2-B,3-C...
6
Long press the channels/power switching button, the RED led flashes three times means
entering image transmission power switching mode. Then short the press channels/power
switching button to switch transmission power. When BLUE led flashes once, it
’
s 25mW;
twice-100mW, 3 times-200mW.
7
When all parameters set, long press the channels/power switching button, the red and
blue leds always on means image transmission saved and normal working status.
Note
Setup won
’
t complete until the last step is done. Otherwise, the setup mode remains and
all the parameters set above can
’
t be saved with success.
As image transmission of F110S is A1 by factory default, table below can be referred to change
corresponding channel if necessary.
Note
8
When installing the image transmission, make sure the heat radiation is considered.
Otherwise, the transmission power will decrease even turn off as the protection of over heating is
activated.
9
It’s advised to install antenna first then power it on so that the life span of image
transmission can be extended to maximum limit.
10
In order to set the MHz and signal switching or auto search on FPV screen/goggle,
please kindly refer to it’s corresponding manual.
Thank you again for choosing RadioLink products.
Channel/MHz
1
2
3
4
5
6
7
8
A
5865M
5845M
5825M
5805M
5785M
5765M
5745M
5725M
B
5733M
5752M
5771M
5790M
5809M
5828M
5847M
5866M
C
5705M
5685M
5665M
5645M
5885M
5905M
5925M
5945M
D
5740M
5760M
5780M
5800M
5820M
5840M
5860M
5880M
E
5658M
5695M
5732M
5769M
5806M
5843M
5880M
5917M
F
5362M
5399M
5436M
5473M
5510M
5547M
5584M
5621M