Radiolink Electronic Limited
6
/
17
Power for F110S
: The voltage of 1S LiPo battery packed with F110S by default is not fully charged
so the battery needs to be charged with the charger CM120 before flight.
The LiPo battery charger CM120, specially designed for 1S LiPo battery, sharing the professional
development and high precision of CB86PLUS, ensures safer charging and battery life span.
Charging current can be set as 1A or 2A by toggling the switch at the side of the charger.
Red LED indicates the battery is under charging and green LED indicates the battery is fully
charged.
CM120 applies general USB connector, both computer and power bank for mobile phone can be
used with CM120.
Note
Voltage output of power supply should be NO higher than 5V.
2.2 Remote Controller
Note
The below example takes RadioLink radio T8FB Mode 2 (Throttle on the left stick) .
The two joysticks of T8FB correspond to the four basic channels respectively .
Left stick
Make the F110S rise or descend by pushing the left stick vertically upward or downward while
make the F110S rotates clockwise or anticlockwise by pushing the left stick to the left or right.
Right stick
Make the F110S flight forward or backward by pushing the right stick vertically upward or
downward while make the F110S flight towards to left or right by pushing the right stick to the left
level or right.
