RD4000 Locating System User Manual
Page 45
RD4000 receiver information codes
The RD4000 incorporates several information codes that are
displayed to show that a requested operation can not be
performed. The information screen will be displayed for
approximately five seconds and clear. The codes and their
meanings are:
Code
Meaning
02
On switch-on, the receiver could not restore the previous settings. This means
that when the receiver is switched on it will switch on in its default settings rather
than those in which it was last switched off.
This is not critical, as the receiver will function normally in all other respects.
05
During a depth reading the top antenna signal is greater than the bottom
antenna. The receiver may be under overhead power cables.
Take a depth reading in another location.
07
While computing the depth a signal has caused one or both antennas to ‘clip’
thus invalidating the depth reading.
Repeat the measurement.
010
An accessory that is not supported by the current receiver software has been
connected to the receiver.
The receiver requires a software update before the accessory can be used.
011
Some ‘intelligent’ accessories have an identification code that tells the receiver
the type of accessory that is connected to the receiver. Code 011 indicates that
the identification code has been lost. Re-try the connection. If this is
unsuccessful, the accessory needs re-programming.
013
A CD reset has been attempted but there is no valid CD signal.
Try to reset again. If unsuccessful, ensure the transmitter connections are the
correct way round.
Radiodetection
mA
mA
Part No: 01.02
RD4000
RD4000