25
Operation
was last reset and
6,1&(
6,1&(
6,1&(
6,1&(
appear simulta-
neously.
• Yesterday’s rainfall amount is calcu-
lated from 12:00 AM of one day to 12:00
AM on the next day.
• If no rainfall is detected for two consecu-
tive hours,
appears on the monitor.
Resetting the Total Rainfall
Record
To reset the total rainfall record in memory
and record new data (beginning with the cur-
rent conditions), press
RAIN
, then hold
down
0(025<
0(025<
0(025<
0(025<
until a beep sounds.
Using the High Rainfall Rate
Alarm
You can set the monitor to sound an alarm
when the rainfall rate meets or exceeds a set
condition (such as 1 in/hr). Each time rain
falls and meets or exceeds the set alarm
condition,
+,
+,
+,
+,
flashes and the monitor sounds
an alarm for about 1 minute. To silence the
alarm sooner, press any key.
Note: If you press a key to silence the alarm,
the alarm stops sounding, but
+,
+,
+,
+,
and current
rainfall rate continue to flash until the alarm
condition is no longer met.
To view the current high rainfall rate alarm
setting, press
RAIN
, then press
ALARM
so
$/$50
$/$50
$/$50
$/$50 +,
+,
+,
+,
appears.
Note: When no rainfall alarm condition is set,
appears.
Setting the High Rainfall Rate
Alarm
Note: If you do not press any button for
about 60 seconds, the monitor returns to the
current alarm condition display. To continue
programming the alarm condition, start over
at Step 2.
1. Press
RAIN
.
2. Repeatedly press
ALARM
until
$$$$/$50
/$50
/$50
/$50 +,
+,
+,
+,
appears.
3. Hold down
SET
for about 2 seconds until
the monitor beeps. The last set alarm
condition (in inches/hour or mm/hour)
flashes.
4. Repeatedly press (or hold down)
or
to adjust the setting.
5. Press
SET
to store the setting.
Clearing the High Rainfall Rate
Alarm Setting
To clear the high rainfall rate alarm condition
so the alarm does not sound, press
RAIN
, then repeatedly press
ALARM
until
$$$$/$50
/$50
/$50
/$50 +,
+,
+,
+,
appears. Repeatedly press
until
appears.
USING THE WIND WINDOW
The weather station uses the anemometer to
sample the wind speed and direction. You
can set the monitor to display the wind speed
in miles per hour (mph), kilometers per hour
(kph), meters per second (m/s), or knots. To
set the wind speed unit of measurement,
press
WIND
, then repeatedly press
UNIT
until the desired unit appears.
The monitor displays wind direction in
degrees (0° to 359° — 0° being due North,
180° being due South, and so on) and literal
compass direction (N for north, S for south,
and so on). The monitor displays the literal
compass wind direction at all times, regard-
less of which window is active.
The anemometer determines gust every 14
seconds and the average wind speed about
every 60 seconds. To toggle between the
gust view and the average wind speed view,
repeatedly press
WIND
, so
*867
*867
*867
*867
or
$9(5$*(
$9(5$*(
$9(5$*(
$9(5$*(
appears.
